Buffers for Crane Systems

LEBEN manufactures hydraulic industrial shock absorbers used as crane buffers for overhead cranes, Goliath cranes, slewing cranes, loading bridges, container cranes and gantry cranes. The buffers act as end stops on the crane travelling mechanism or trolley and absorb kinetic energy at the end of travel. As inter-crane buffers, they can also damp collisions between two cranes sharing the same runway.

The design is based on the specific load case and crane system requirements. Depending on the application, DIN EN 15011 and the relevant parts of DIN EN 13001 may apply to overhead and gantry cranes. Other agreed rules, such as FEM 1.001 or AISE’s Technical Report No. 6, are assigned to the individual project. The applicable editions are defined for each project. Key parameters include mass, impact velocity, available buffer stroke and permissible forces and decelerations.

Crane Buffers

Crane Buffers as End-Position Damping for Gantry, as Crane Gantry Buffers, and for Trolley as Trolley Buffers:

Problem:

If the electrical end limit fails, or the remaining travel speed is too high, the crane travelling mechanism or trolley may strike its end stops. An undamped impact loads the wheels, travelling mechanism, crane runway and supporting structure. In the case of the trolley, its track and adjacent components may also be damaged. The design must therefore consider the actual movement acting on the buffer and any additional driving forces.

Solution:

Hydraulic crane buffers are mounted on the moving crane or installed at stationary end stops on the runway. Trolley buffers perform the same function for the trolley. As the piston rod is compressed, the absorbed energy is converted into heat through the damping medium. The damping characteristic is matched to the available stroke and permissible reaction force. For buffers arranged in parallel, the actual load distribution and mounting points are included in the design.

Advantage:

Crane travel buffers and trolley buffers reduce impact forces and decelerations. In the design impact event, they prevent injury to personnel and damage to the crane and building. The defined buffer stroke enables controlled deceleration to a standstill and protects the connected supporting structure.

Intermediate Buffers (as Crane Gantry Buffers, Crane against Crane):

Problem:

Several cranes sharing a runway may collide head-on or one crane may run into another. This load case differs from an impact against a stationary end stop: the masses and velocities of both cranes, together with the arrangement of opposing buffers, determine the energy input. Different loading conditions further change the design parameters.

Solution:

COMPENSER® S-Series units can be used as inter-crane buffers for this application. These gas-hydraulic heavy-duty buffers are matched to the permissible damping force and deceleration of the crane system. The cranes and their buffers are considered as an interacting system during selection. This includes the total usable travel, load distribution and the forces transmitted into the supporting structure through the buffer mountings.

Advantage:

Inter-crane buffers reduce the impact forces and decelerations transmitted when two cranes come into contact. They protect personnel, cranes and buildings against harm in the design head-on or rear-end collision. Loads on the crane travelling mechanisms are also limited, helping to prevent impact-related downtime.

Crane Buffers Gantry Crane Buffers Trolley

Application Examples

Crane buffers
Crane buffers
Hydraulic crane buffer
Hydraulic crane buffer